Background Illustrations provided by: http://edison.rutgers.edu/
Reblogged from eltiron  5 notes
eltiron:

“Schwezoff Dávidot a BZSH július 3-ai közgyűlésén választották meg a szervezet ügyvezető igazgatójává. Elődje, Zoltai Gusztáv, aki 1991 óta töltötte be ezt a tisztséget, április 9-én mondott le. Megválasztása után derült ki, hogy Schwezoff Dávid transzvesztita előadóként és katolikus kántorként is tevékenykedett, de járt evangélikus lelkészképzésre is.”
/index/
Ennél jobbat én ma már nem olvashatok, fetrengek.

Ez mekkora troll! :D

eltiron:

Schwezoff Dávidot a BZSH július 3-ai közgyűlésén választották meg a szervezet ügyvezető igazgatójává. Elődje, Zoltai Gusztáv, aki 1991 óta töltötte be ezt a tisztséget, április 9-én mondott le. Megválasztása után derült ki, hogy Schwezoff Dávid transzvesztita előadóként és katolikus kántorként is tevékenykedett, de járt evangélikus lelkészképzésre is.”

/index/

Ennél jobbat én ma már nem olvashatok, fetrengek.

Ez mekkora troll! :D

Reblogged from e5271  18 notes
e5271:

irour:

ksszns:

Andrea Rossi’s E-Cat — the device that purports to use cold fusion to generate massive amounts of cheap, green energy – has been verified by third-party researchers, according to a new 54-page report. The researchers observed a small E-Cat over 32 days, where it produced net energy of 1.5 megawatt-hours, or “far more than can be obtained from any known chemical sources in the small reactor volume.” The researchers were also allowed to analyze the fuel before and after the 32-day run, noting that the isotopes in the spent fuel could only have been obtained by “nuclear reactions” — a conclusion that boggles the researchers: “… It is of course very hard to comprehend how these fusion processes can take place in the fuel compound at low energies.”
http://www.extremetech.com/extreme/191754-cold-fusion-reactor-verified-by-third-party-researchers-seems-to-have-1-million-times-the-energy-density-of-gasoline

Mijafasz?!

aztakurva

!

e5271:

irour:

ksszns:

Andrea Rossi’s E-Cat — the device that purports to use cold fusion to generate massive amounts of cheap, green energy – has been verified by third-party researchers, according to a new 54-page report. The researchers observed a small E-Cat over 32 days, where it produced net energy of 1.5 megawatt-hours, or “far more than can be obtained from any known chemical sources in the small reactor volume.” The researchers were also allowed to analyze the fuel before and after the 32-day run, noting that the isotopes in the spent fuel could only have been obtained by “nuclear reactions” — a conclusion that boggles the researchers: “… It is of course very hard to comprehend how these fusion processes can take place in the fuel compound at low energies.”

http://www.extremetech.com/extreme/191754-cold-fusion-reactor-verified-by-third-party-researchers-seems-to-have-1-million-times-the-energy-density-of-gasoline

Mijafasz?!

aztakurva

!

Reblogged from purple-cosmos  83,314 notes
sixpenceee:

Sticking tape on a frosted glass makes it see through. Air and glass have a very different refractive index, so if you have a rough glass surface, the incoming light is scattered in all directions, thus blurring the image you see through it.
Tape has a similar refractive index as glass, so if you stick it to frosted glass, the sticky material will fill out the little bumps in the glass. The non-sticky side is practically flat, so by sticking tape to the frosted side of glass that’s frosted on one side, you are essentially making it flat again, and making the glass clear. 

sixpenceee:

Sticking tape on a frosted glass makes it see through. Air and glass have a very different refractive index, so if you have a rough glass surface, the incoming light is scattered in all directions, thus blurring the image you see through it.

Tape has a similar refractive index as glass, so if you stick it to frosted glass, the sticky material will fill out the little bumps in the glass. The non-sticky side is practically flat, so by sticking tape to the frosted side of glass that’s frosted on one side, you are essentially making it flat again, and making the glass clear.